Thoroughly adhere to these instructions to prevent any potential leakage issues.
1. Establish the connection:
Ensure the tube is cut squarely and free from any score marks. For a flawless cut, we suggest using a new, sharp cutter. When dealing with soft or thin-walled plastic tubes, employing a tube insert is recommended.
2. Standard Connection Procedure:
Insert the tubing as far as it can go using regular hand pressure.
Push the pipe into the fitting
until it reaches the pipe stop. The collector (gripper) features stainless steel teeth that securely
hold the pipe in place, while the 'O' Ring ensures a permanent, leak-proof seal.
Give the pipe a gentle
tug to confirm its secure positioning. It's advisable to test the system for reliability before leaving
the site or prior to use.
Installation Guide for Male Elbow Fitting
1. Insert the male elbow fitting into the right-side inlet feed water
Ensure the elbow is positioned straight inside the female port of the filter housing.
Screw the elbow fitting counterclockwise approximately 6 to 7 turns maximum. Hand-tighten only.
Fully insert the tubing into the fitting. Push firmly by hand.
Reinsert the locking clip.
2. Repeat the same steps for the left-side outlet port.
Screw the elbow fitting counterclockwise about 6 to 7 turns maximum. Hand-tighten only.
Screw the elbow fitting counterclockwise about 6 to 7 turns maximum. Hand-tighten only.
Remove the locking clip.
